DURANTE Garage Tiles Care and Maintenance Guide
To keep your Durante tiles looking their best and ensure longevity, please follow this care and maintenance guide.
General Maintenance:
1- Regular Cleaning:
- Dirt will fall underneath the tiles to keep the surface clean and prevent you from tracking that dirt into your home. When the area is fully dry, you can use a vacuum cleaner to suction up the dirt from underneath.
- Mud can be hosed and washed away underneath the tiles outside the garage or to your drain point.
- For the rare deep clean, you can remove the last rows of the tiles on each side and slide out the remaining tiles still interlocked like a carpet, for a thorough deep clean of the concrete underneath.
2- Washing:
- Mild Detergent: Mix a mild detergent with warm water and use a soft mop or cloth to clean the tiles.
- Rinse Thoroughly: Ensure all detergent residue is rinsed off with clean water to prevent slipping and ensure a clean surface.
- Drying: Allow tiles to air dry.
Spills:
1- Common Spills:
- Oil and Grease: You may remove the tiles even in the middle of an area using a larger metal hook that fits into the gaps to expose the oil spill underneath. Soak up whatever oil and grease you can with paper towels, then use a degreaser suitable for polypropylene surfaces on both the tile and the concrete underneath to clean the remainder of the oil/grease spill. Let the degreaser sit for a few minutes, then wipe off, or if possible, hose it off.
2- Stubborn Stains:
- Stain Remover: Use a commercial stain remover safe for polypropylene. Follow the manufacturer’s instructions.
- Scrubbing: Use a soft-bristled brush for gentle scrubbing. Avoid using abrasive pads that may scratch the tiles.
Special Considerations:
1- Chemical Exposure:
- Avoid Harsh Chemicals: Do not use solvents, bleach, or acidic cleaners not meant for polypropylene as they can cause damage to the tiles.
- Safe Cleaners: Opt for pH-neutral cleaners designed for polypropylene surfaces.
2- Heat and Fire Safety:
- Avoid Direct Heat: Do not place hot objects directly on the tiles to prevent melting or warping.
- Fire Safety: Keep tiles away from open flames or heat sources exceeding 120°C (248°F).
Preventative Measures:
1- Furniture and Heavy Objects:
- Protective Pads: Use furniture pads under heavy objects to prevent indentations and scratches.
- Avoid Dragging: Lift and place objects instead of dragging them across the tiles.
2- Environmental Factors:
- UV Protection: DURANTE tiles are UV resistant, but prolonged exposure to direct sunlight may cause slight discoloration over time. Consider using shades or blinds in areas with intense sunlight.
- Temperature Fluctuations: DURANTE tiles are designed to withstand temperature variations but avoid extreme conditions where possible.
Routine Inspection:
1- Check for Loose Tiles:
- Regular Inspection: Periodically check for any loose tiles and snap them back into place if necessary.
- Edge and Corner Tiles: Pay special attention to edge and corner tiles as they are more prone to loosening.
2- Tile Replacement:
- Damaged Tiles: Replace any damaged tiles promptly to maintain the integrity of the flooring.
- Matching Tiles: Keep a few extra tiles from the original installation batch for seamless replacements.
Additional Tips:
If you experience movement in the tiles shifting or unclipping:
- Double check that you have left 10mm gap against each wall/post to allow for heat expansion.
- Driving cars on an unrestrained Durante tiled area can also cause them to move. In this instance you have two options:
- Drill through the provided anchor holes in the ramp edges into your concrete floor, and apply anchor screws into them, locking the ramps and therefore the entire Durante tiled area in place.
- The same effect can be achieved by using a strong construction adhesive like liquid nail at the ramp edges instead of anchoring them with screws, but this is a non-removable option.
For more information or assistance, please contact our customer support.
